ZE3127S Extra Modules And Spare Parts Teaching Equipment Educational Training Equipment 1.Data acquisition module 1 piece Operation instructions: (1) the "L1 and N" on the module hanger is provided by power output terminals on the power box. (2) "Torque input, Speed input" air plug seat, which is connected to the Torque sensor using a special aviation plug line (blue box); "USB out" uses a dedicated cable to connect to a computer for communication. 2.Semi-controlled bridge thyristor module 1 piece Operation instructions: Semi-controlled bridge thyristor module hanging box can complete the half-control bridge rectifier experiment. 3.Three-phase rectifier module 1 piece Operation instructions: (1) "L1, L2 and L3" on the module hanger are provided by power output terminals of the three-phase AC380V power supply box on the power box. (2) the dc voltage of "+, -" output DC550V on the module hanger. 4.Siemens inverter module 1 piece 5.DC semiconductor thyristor drive module (1) product features: PWM pulse width modulation. It adopts SMT technology and small volume. It is suitable for rare earth, permanent magnet type, he excited type and dc torque motor. Double closed loop P I regulation (voltage, current) It has good following and quick response. The speed regulation ratio is wider and the mechanical properties are hard. It is limited to current protection and short circuit protection. The starting torque is large at low speed. It enables the control function. Soft start setting function. Standard signal input or 2W/10K potentiometer control drive speed control. (2). Technical parameters: Input voltage AC: 220V (other voltage can be customized according to customer requirements) Output voltage DC: 0-220v (set) Output voltage accuracy: less than 0.1. Rated output current: 4A. Speed regulation ratio: 100:1. Standard signal: 0-5v, 0-10v, 4-20ma. Soft start time: 0.2s-10s. - environmental temperature: - 10 ℃ ~ + 60 ℃ Environmental humidity: the relative humidity is no more than 65. Instantaneous short circuit protection: 50us. Insulation pressure: 1500V AC. - insulation resistance: > 500 m Ω Leakage current: less than 0.09mA. (3) product performance: 1. With a hard mechanical characteristic, the static error rate is 1%. 2. With wide speed range, (0 - MAX speed MAX SPD set value). 3. It has a fast dynamic response process. 4. Automatic smooth transition process with addition and deceleration. 5. Can automatically limit the overload current to the set value current. 6. High reliability, compact structure, high cost performance. 6.Single-quadrant DC drive module 1 piece (1) The DC brushless motor and rotary encoder are fixed on the base board and connected with the coupling, and the encoder terminals are connected to the speed table by using the aviation plug test line. (2) Connect the DC brushless motor to the drive according to the following figure. EN and DIR use the 2mm safety cable, connected to GND1 terminal by switch (switch potentiometer hang box ZE3115S-module -1). Can realize start-stop and forward control. 7.Server driver module 1 piece (1) connect the servo motor in the ZE3125S single phase ac motor, and connect "U, V, W, PE" to the "U, V, W, PE" terminal of the servo drive using the 4MM SAFETY test line; (2) use the servo motor special line to connect to the "CN3" terminal; (3) use the 4mm safety electrical cable of L1, L2, L3 and PE on the power box to the servo drive L1, L2, L3 and PE terminals for test debugging. 8.Electromagnetic brake 1 piece 9. Load calibration module 1 piece
