WL 102 Change of State of Gases Trainer Didactic Equipment Thermal Training Equipment
Gas laws belong to the fundamentals of thermodynamics and are dealt with in every training course on thermodynamics. The WL 102 experimental unit enables two changes of state to be studied experimentally: isothermal change of state, also known as the Boyle-Mariotte law, and isochoric change of state, which occurs at constant volume. Transparent tanks enable the change of state to be observed. Air is used as the test gas. In the first tank, positioned on the left, the hermetically enclosed air volume is reduced or increased using a compressor and hydraulic oil. This results in an isothermal change of state. The compressor can also operate as a vacuum pump. If the changes occur slowly, the change of state takes place at an almost constant temperature. In the second tank, positioned on the right, the temperature of the test gas is increased by a controlled electric heater and the resulting pressure rise is measured. The volume of the enclosed gas remains constant. Temperatures, pressures and volume are measured electronically, digitally displayed and transferred to a PC for processing. Specification experimental investigation of gas laws transparent measuring tank 1 for investigation of isothermic change of state hydraulic oil filling for changing volume of test gas test gas volume determined by level measurement in the tank with differential pressure sensor built-in compressor generates necessary pressure differences to move the oil volume compressor can also be used as vacuum pump 5/2-way valve for switching between compression and expansion transparent measuring tank 2 for investigation of isochoric change of state electrical heater with temperature control in tank 2 sensors for temperatures, pressures in both tank digital displays for temperatures, pressures and volume software for data acquisition via USB under Windows 8.1, 10 Technical data Compressor / vacuum pump power output: 60W pressure at inlet: 213mbar pressure at outlet: 2bar Temperature controller: PID, 300W, limited to 70°C Measuring ranges temperature: tank 1: 0…70°C tank 2: 0…70°C pressure: tank 1: 0…4bar abs. tank 2: 0…2bar abs. volume: tank 1: 0…3L 230V, 50Hz, 1 phase 230V, 60Hz, 1 phase; 120V, 60Hz, 1 phase UL/CSA optional
