SS1102C Instrumentation Training kit Teaching equipment Electrical Lab Equipment
I. The introduction of the experimental device
The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Let students practice troubleshooting. See Appendix 1 for the relative position of the fault repair switch. The fault switch of each template is factory-based, based on the principle that the circuit works normally. Place the switch in the normal position after troubleshooting.
II. Technical parameters
(1) Input power: two-phase three-wire system 220V±10% 60Hz
(2) Weight: Around <50kg
III. Training Kit including Installation, Commissioning and Testing
Kits consisting of the following modules:
Temperature Regulator with PID controller
Thermal Sensors (Photoconductive cell, Phototransistor, Linear variable differential transformer- LVDT)
Buffers and Inverters
Comparator with switchable hysteresis
Amplifiers with gain and offset control (Current amplifier， Summing amplifier, Differential amplifier, Instrumentation amplifiers )
Filter (Low-pass filter with switchable time constant)
Integrator and Differentiator with switchable time-constant
Voltage/Frequency and Voltage/Current converters
Operating voltage: 230V (50 Hz)
Warranty Period: Minimum One Year on equipment
