ZM3199 Motion Control Trainer Motion control training equipment Teaching Equipment Overview: This device can realize the sensor detection, transaction processing, intelligent control and execute drive of production line. It refer to basis knowledge and basis electromechanical skill requirement of mechanical technique, micro electronic technique, electrical and electronic technology, sensor detection technology, interface technology, information transformation technology, network communication technology and other mechatronics major. Function characteristic: 1. This system adapt industrial aluminum profile structure, the aluminum rail type training workbench is equipped with three basic unit: small car back and forth movement( pay-off ), three degree of freedom manipulator( carry ), sensor detection( material identification, distance detection, count, etc ), it can be used for single actuator, it also can make up a machinery platform of typical automatic production line. 2. System mechanism adapt cylinder driver, frequency conversion adjustable-speed motor driver, DC motor driver. PLC and transducer control interface totally open, it can arbitrary outer connect control, it can adapt module combined type structure, each working unit are relatively independent module, it adapt standard structure and drawer type module, it has stronger interchangeability. 3. Manipulator mechanism hardware protection circuit. It can carry out judge the position signal of manipulator and output signal of PLC, the actuating signal of accord with logical function is manipulator response actuating signal, otherwise, it will failure to actuate, thus it realize machinery coordinate protection. 4. It is equipped with various industry common sensor, promote the signal data collection ability of equipment, it is convenient for student programme and the reliable of whole mechanism operation. It can make the student master the principle of various sensor and the application of practical work, use different sensor to realize different or same function. 5. According to upper computer WINCC configuration software to carry out networking communications, it can support 485, MODBUS, DP network and Ethernet to carry out data exchange. Specification: 1．Boundary dimension: 1240(L)× 720(W)× 1300(H) mm (drawer don’t stretch out) 2．Max. Sorting speed: 20 times/ minute 3．Continuous automatic sorting operation time: 24hours continuous sorting times: 28800times/day 4．Rated working power supply: AC：220V 50 Hz Main work power：1.2 Kw 5．Rated working air pressure: 0.3-0.4 MPa 6．Work environment: temperature-10℃～35℃ relative humidity≤85%(25℃)
